Tekelec IP7 Secure Gateway Administration Manual page 741

Database Administration Manual - IP7 Secure
Gateway
From
Sheet 1
Yes
200 or
greater
To
Sheet 4
Sheet 3 of 4
910-6278-001 Revision A, January 2012
Enter the
rtrv-m2pa-tset command.
Is the desired
M2PA timer set
No
defined with the desired
values? See
the Note.
Yes
Was a new host
name added on
Sheet 2?
No
Enter the rtrv-assoc
command with this
parameter.
:lhost=<local host name
that will be assigned to the
new association>
Less than
What is the
200
available buffer size of the
card that the association will
be assigned to ?
IPSG M2PA and M3UA Configuration Procedures
Perform the "Changing an
M2PA Timer Set " procedure in
this chapter and change the
desired timer set with the
desired values. See the
Caution.
Note: If the m2patset parameter
will not be specified with the
ent-assoc command, the RFC
version of M2PA timer set 1 will
be assigned to the association.
From
Sheet 2 Caution: Changing an M2PA
timer set may affect the
performance of any
associations using the timer set
being changed.
Do you wish to
change the buffer size
of any of the associations
currently assigned to the
card?
Yes
Perform the Changing the Buffer Size
of an IPSG Association" procedure to
change the buffer size of the
associations assigned to the card to
allow the new association to be added
to the card.
No
The new association
cannot be added.
741