Tekelec IP7 Secure Gateway Administration Manual page 695

Database Administration Manual - IP7 Secure
Gateway
4. Retrieve the status of the signaling links assigned to the IP card to be changed using the
rept-stat-slk command.
For example, enter this command.
rept-stat-slk:loc=1201:link=a
The output lists the signaling link assigned to this card:
rlghncxa03w 06-10-28 21:16:37 GMT EAGLE5 36.0.0
SLK LSN
1201,A nc001
Command Completed.
If the signaling link is in service-normal (IS-NR), continue the procedure with
the signaling link. If the signaling link is out-of-service-maintenance disabled (OOS-MT-DSBLD),
continue the procedure with
5. Deactivate the signaling links assigned to the IP card using the dact-slk command.
For example, enter this command.
dact-slk:loc=1201:link=a
CAUTION: This command impacts network performance and should only be used
during periods of low traffic.
After this command has successfully completed, this message appears.
rlghncxa03w 06-10-12 09:12:36 GMT EAGLE5 36.0.0
Deactivate Link message sent to card.
6. Verify the new link status using the rept-stat-slk command.
For example, enter this command.
rept-stat-slk:loc=1201:link=a
The output displays the link status as OOS-MT-DSBLD and gives off a minor alarm:
rlghncxa03w 06-10-27 17:00:36 GMT EAGLE5 36.0.0
SLK LSN
1201,A nc001
ALARM STATUS = * 0236 REPT-LKS:not aligned
UNAVAIL REASON = NA
Command Completed.
7. Verify the status of the IP card to be inhibited using the rept-stat-card command.
For example, enter this command.
rept-stat-card:loc=1201
This is an example of the possible output.
rlghncxa03w 10-12-01 09:12:36 GMT EAGLE5 43.0.0
CARD VERSION
1201 133-003-000
ALARM STATUS
BLIXP GPL version = 133-003-000
910-6278-001 Revision A, January 2012
IPSG M2PA and M3UA Configuration Procedures
CLLI PST
----------- IS-NR
Step 7 to verify the IP card status.
CLLI PST
----------- OOS-MT-DSBLD AVAIL
TYPE GPL
E5ENET IPSG
= No Alarms.
SST AST
SST AST
---
PST SST
IS-NR Active
Step 5
to deactivate
AST
-----
695