Table 42: Valid Pvalue Parameter Values If Parm=1 - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
6 – Broadcast Congestion Status Change – controls the sending of unsolicited congestion status
changes by an ASP. Unsolicited congestion status messages (TFCs generated when a destination's
congestion status changes) are replicated to all ASPs who have this capability and meet the
Multicast SNM Criteria. The default is to generate no unsolicited congestion status changes.

Table 42: Valid PVALUE Parameter Values if PARM=1

parameter if the parm value is 1. The pvalue parameter value can be entered as a hexadecimal or
a decimal number.
Table 42: Valid PVALUE Parameter Values if PARM=1
Bits Enabled
None
Bit 0 - Broadcast
Bit 1 - Response Method
Bit 0 - Broadcast
Bit 1 - Response Method
Bit 6 - Broadcast Congestion Status
Change
Bit 6 - Broadcast Congestion Status
Change
Bit 0 - Broadcast
Bit 6 - Broadcast Congestion Status
Change
Bit 1 - Response Method
Bit 0 - Broadcast
Bit 1 - Response Method
910-6278-001 Revision A, January 2012
IETF M3UA and SUA Configuration Procedures
shows the values can be entered for the pvalue
Bits Disabled
Bit 0 - Broadcast
Bit 1 - Response Method
Bit 6 - Broadcast Congestion Status
Change
Bit 1 - Response Method
Bit 6 - Broadcast Congestion Status
Change
Bit 0 - Broadcast
Bit 6 - Broadcast Congestion Status
Change
Bit 6 - Broadcast Congestion Status
Change
Bit 0 - Broadcast
Bit 1 - Response Method
Bit 1 - Response Method
Bit 0 - Broadcast
None
Hexadecimal Decimal
Value Value
h'0 0
h'1 1
h'2 2
h'3* 3*
h'40 64
h'41 65
h'42 66
h'43 67
609