Tekelec IP7 Secure Gateway Administration Manual page 188

Database Administration Manual - IP7 Secure
Gateway
For this example, enter this command.
chg-assoc:aname=assoc2:open=yes
When this command has successfully completed, this message should appear.
rlghncxa03w 06-10-28 09:12:36 GMT EAGLE5 36.0.0
CHG-ASSOC: MASP A - COMPLTD;
11. Verify the changes using the rtrv-assoc command specifying the association name specified in
Step 9 and Step
For this example, enter this command.
rtrv-assoc:aname=assoc2
This is an example of possible output.
rlghncxa03w 10-07-28 21:14:37 GMT EAGLE5 42.0.0
ANAME assoc2
LOC
ADAPTER
LHOST
ALHOST
RHOST
ARHOST
LPORT
ISTRMS
RMODE
RTIMES
OPEN
RHOSTVAL MATCH
IP Appl Sock/Assoc table is (8 of 4000) 1% full
Assoc Buffer Space Used (1600 KB of 1600 KB) on LOC = 1205
12. Back up the new changes, using the chg-db:action=backup:dest=fixed command.
These messages should appear; the active Maintenance and Administration Subsystem Processor
(MASP) appears first.
BACKUP (FIXED) : MASP A - Backup starts on active MASP.
BACKUP (FIXED) : MASP A - Backup on active MASP to fixed disk complete.
BACKUP (FIXED) : MASP A - Backup starts on standby MASP.
BACKUP (FIXED) : MASP A - Backup on standby MASP to fixed disk complete.
If you wish to change the lhost, alhost, bufsize, or link values of the M2PA association,
perform one of these procedures.
lhost and alhost -
bufsize -
link - Changing the Link Value of a M2PA Association to another Link Value on the Same IPLIMx
Card
If you do not wish to change the lhost, alhost, bufsize, or link values of the M2PA association,
this procedure is finished.
910-6278-001 Revision A, January 2012
10.
1205 IPLNK PORT
M2PA VER
IPNODE2-1205
---
gw200.nc-tekelec.com
gw210.nc-tekelec.com
2048 RPORT
2 OSTRMS
LIN RMIN
10 CWMIN
YES ALW
M2PATSET
Changing the Host Values of a M2PA Association
Changing the Buffer Size of a M2PA Association
IETF M2PA Configuration Procedures
A LINK A
M2PA RFC
3000
2 BUFSIZE
120 RMAX
3000 UAPS
NO RTXTHR
1
400
800
10
10000
188