Tekelec IP7 Secure Gateway Administration Manual page 863

Database Administration Manual - IP7 Secure
Gateway
Total provisioned System TPS (103668 of 500000) 21%
Command Completed.
If the RSVDSLKTPS or the MAXSLKTPS values of each linkset shown in
maximum total provisioned system TPS value shown in the rtrv-tps output, continue the
procedure with
If the RSVDSLKTPS or the MAXSLKTPS values of any linkset shown in
maximum total provisioned system TPS value shown in the rtrv-tps output, continue the
procedure by performing one of these actions.
If the maximum total provisioned system TPS value is 500,000, perform the "Activating the
HIPR2 High Rate Mode Feature" procedure in the Database Administration Manual - System
Management to increase the maximum total provisioned system TPS value to 750,000. After the
"Activating the HIPR2 High Rate Mode Feature" procedure has been performed, continue the
procedure with
If the maximum total provisioned system TPS value is 750,000, perform the
M2PA Linkset
value if necessary, of the linksets shown in
IPSG card with this procedure. After the
performed, continue the procedure with
8. Change the IPLIMx card to an IPSG card by entering the chg-card command with the card location
of the card being changed and the new card application, ipsg.
For this example, enter this command.
chg-card:loc=1303:nappl=ipsg
When this command has successfully completed, this message should appear.
rlghncxa03w 10-07-10 16:20:46 GMT
CHG-CARD: MASP A - COMPLTD
9. Verify that the card has been changed by entering the rtrv-card command with the card location
specified in Step
For this example, enter this command.
rtrv-card:loc=1303
This is an example of the possible output.
rlghncxa03w 10-07-10 16:20:46 GMT
CARD TYPE
1311 ENET
10. Display the linksets that were displayed in
name of each linkset that was specified in
For this example, enter these commands.
rtrv-ls:lsn=ipnode1
This is an example of possible output.
rlghncxa03w 10-07-17 11:43:04 GMT EAGLE5 42.0.0
910-6278-001 Revision A, January 2012
Step 8.
Step 8
procedure as necessary to change the MAXSLKTPS value, and the RSVDSLKTPS
8.
APPL LSET NAME
IPSG ipnode1
IPSG M2PA and M3UA Configuration Procedures
Step 2 to allow the IPLIMx card to be changed to an
Changing an IPSG M2PA Linkset
Step 8.
EAGLE 42.0.0
EAGLE 42.0.0
LINK SLC LSET NAME
A 0 ipnode3
Step 5 by entering the rtrv-ls command with the
Step 5.
Step 5 will not exceed the
Step 5 will exceed the
Changing an IPSG
procedure has been
LINK SLC
B 0
863