Tekelec IP7 Secure Gateway Administration Manual page 1004

Database Administration Manual - IP7 Secure
Gateway
no stored transmit discard data
Stored Receive Discard Data
---------------------------
53 41 53 49 69 73 6f 74 11 00 87 0a 01 03 01 05
05 00 01 02 03 04 05 06 07 08 09 00 00 00 00 00
END of Report
If the outputs of the pass commands in
association, contact the Customer Care Center. Refer to
information.
24. At the IP near end node, activate all the other associations attached to the IP card specified in
23.
25. Repeat Step 4 through
M3UA associations with the new SCTP checksum algorithm.
26. Back up the new changes using the chg-db:action=backup:dest=fixed command. These
messages should appear, the active Maintenance and Administration Subsystem Processor (MASP)
appears first.
BACKUP (FIXED) : MASP A - Backup starts on active MASP.
BACKUP (FIXED) : MASP A - Backup on active MASP to fixed disk complete.
BACKUP (FIXED) : MASP A - Backup starts on standby MASP.
BACKUP (FIXED) : MASP A - Backup on standby MASP to fixed disk complete.
27. If the rtrv-card output in
the Changing the SCTP Checksum Algorithm Option for M2PA Associations
If the rtrv-card output in
perform the Changing the SCTP Checksum Algorithm Option for M3UA and SUA Associations
If the rtrv-card output in
SS7IPGW, or IPGWI applications, this procedure is finished.
910-6278-001 Revision A, January 2012
Step 22
Step 24 to update the other IPSG cards in the EAGLE 5 ISS that contain IPSG
Step 2
shows cards running the IPLIM or IPLIMI applications, perform
Step 2 shows cards running the SS7IPGW or IPGWI applications,
Step 2 shows that there are no cards running the IPLIM, IPLIMI,
IPSG M2PA and M3UA Configuration Procedures
and Step 23 show that traffic is not flowing over the
Customer Care Center for the contact
Step
procedure.
procedure.
1004