Tekelec IP7 Secure Gateway Administration Manual page 890

Database Administration Manual - IP7 Secure
Gateway
Enter the rtrv-ls
command.
What is the
M3UA
ADAPTER value of the
Perform the
Removing an IPSG
M3UA Signaling Link"
procedure to remove
all the IPSG M3UA
signaling links from
this linkset.
Enter the chg-ls
command with these
parameters.
:lsn=<the name of the
linkset>
:adapter=m2pa
Sheet 1 of 5
910-6278-001 Revision A, January 2012
Enter the rtrv-ls command
with this parameter.
:lsn=<the name of the
linkset>
Yes
What is the
IPSG value?
linkset?
M2PA
Do you wish to
change the RSVDSLKTPS
or the MAXSLKTPS values
for the linkset?
Yes
The new RSVDSLKTPS value for
the linkset cannot allow the sum of
the TPS used by all the IPSG
signaling links that are assigned to
each IPSG card shown in the
linkset to exceed 5000 and cannot
exceed the maximum total
provisioned system TPS.
The new MAXSLKTPS value for the
linkset cannot exceed the maximum
total provisioned system TPS.
Enter the
rtrv-slk command with this
parameter.
:loc=<IPSG card location>
Repeat this step for each card
shown in the individual linkset,
the linkset that is being
changed, that was displayed on
this sheet.
IPSG M2PA and M3UA Configuration Procedures
Do you wish
to change this
linkset?
What is
No
the IPGWAPC
No
Perform the Removing a
Linkset Containing SS7
Signaling Links"
No
procedure to remove the
To
Sheet 5
Perform the Adding an
IPSG M2PA Linkset"
procedure to add the
IPSG M2PA linkset .
Perform the Adding an
IPSG M2PA Signaling
Link" procedure to add
IPSG M2PA signaling
links to this linkset.
Will the new
RSVDSLKTPS value exceed
the maximum 5000 TPS limit
for the card?
No
To
Sheet 2
No
Yes
value?
Yes
linkset.
Yes
Choose another
value for the
RSVDSLKTPS
value that will not
exceed the
maximum 5000
TPS limit for the
card.
890