Tekelec IP7 Secure Gateway Administration Manual page 899

Database Administration Manual - IP7 Secure
Gateway
Removing an IPLIMx Signaling Link
After the signaling links have been removed from the linkset, continue the procedure
with
If the IPSG value of the linkset is yes, continue the procedure with one of these steps.
If the ADAPTER value of the linkset is M2PA, remove the signaling links from the linkset by
performing these procedures as necessary.
Removing an SS7 Signaling Link in the Database Administration Manual - SS7.
Removing an IPLIMx Signaling Link
Removing an IPSG M2PA Signaling Link
After the signaling links have been removed from the linkset, continue the procedure
with
is A, continue the procedure with
If the ADAPTER value of the linkset is M3UA, continue the procedure with one of these steps.
If the RSVDSLKTPS value of the linkset will not be changed, continue the procedure
with
If the RSVDSLKTPS value of the linkset will be changed, continue the procedure with
Step
3. Change the IPSG value of the linkset by entering the chg-ls command with the ipsg=yes
parameter and the name of the linkset that is being changed. For this example, enter this command.
chg-ls:lsn=lssg1101:ipsg=yes
When the chg-ls command has successfully completed, this message should appear.
rlghncxa03w 08-04-20 13:34:40 GMT
Link set table is (13 of 1024) 1% full.
CHG-LS: MASP A - COMPLTD
After the IPSG value of the linkset has been changed, continue the procedure with
When the IPSG value is changed to yes, the ADAPTER value of the linkset is set to m2pa, the
RSVDSLKTPS value of the linkset is set to 5000.
4. The linkset type of an IPSG M3UA linkset must be A. If the linkset type of the linkset is not A,
change the linkset type of the linkset by entering the chg-ls command with the name of the linkset
and the lst=a parameter. For this example, enter this command.
If the linkset type of the linkset is A, this step does not need to be performed. Continue the procedure
with Step 5.
chg-ls:lsn=lssg1101:lst=a
When the chg-ls command has successfully completed, this message should appear.
rlghncxa03w 08-04-20 13:34:40 GMT
Link set table is (13 of 1024) 1% full.
910-6278-001 Revision A, January 2012
Step 3
Step 4 if the linkset type for the linkset is B, C, D, or E. If the linkset type of the linkset
Step 12.
5.
IPSG M2PA and M3UA Configuration Procedures
Step 5.
EAGLE5 38.0.0
EAGLE5 38.0.0
Step 5.
899