Tekelec IP7 Secure Gateway Administration Manual page 866

Database Administration Manual - IP7 Secure
Gateway
The card is not an E5-ENET
card that is assigned to the
IPLIM or IPLIMI application.
Choose another card.
Enter the dact-slk command with these
parameters.
:loc=< the card location of the IPLIMx card
that is being changed>
:link=< the link value of the signaling link
that is not OOS-MT-DSBLD>
Repeat this step for all the signaling links
shown in the rept-stat-card output that are
not OOS-MT-DSBLD.
Sheet 1 of 4
910-6278-001 Revision A, January 2012
IPSG M2PA and M3UA Configuration Procedures
Enter the rtrv-card
command.
Are cards assigned
to the IPLIM or IPLIMI
application shown in the
rtrv-card output?
Yes
Enter the rept-stat-card command
with this parameter.
:loc=< the card location of the
IPLIMx card that is being
changed>
Is the value
No
in the TYPE column
ENET?
Yes
Are signaling
links shown in the
rept-stat-card
output?
Yes
Is the state of all
No
the signaling links
assigned to the card
OOS-MT-DSBLD?
This procedure
No
cannot be
performed.
This procedure cannot be
performed on this card.
Perform the Removing an
IPLIMx Card" to remove this
No
card. Perform the procedures
in the IPSG M2PA and M 3UA
Configuration Procedures
chapter to configure an IPSG
card with IPSG M2PA
signaling links.
Yes
To
Sheet 2
866