Tekelec IP7 Secure Gateway Administration Manual page 997

Database Administration Manual - IP7 Secure
Gateway
sccp class
sccp called party
sccp calling party
isup sio
normalization error
error in XSRV packet
M3UA PDU error
SUA PDU error
invalid rcontext
Stored Transmit Discard Data
----------------------------
no stored transmit discard data
Stored Receive Discard Data
---------------------------
53 41 53 49 69 73 6f 74 11 00 87 0a 01 03 01 05
05 00 01 02 03 04 05 06 07 08 09 00 00 00 00 00
END of Report
7. At the IP near end node, disconnect all the associations attached to the IP card specified in
8. At the EAGLE 5 ISS, place the signaling link on this IP card out of service using the dact-slk
command. For this example, enter this command.
dact-slk:loc=1315:link=a
When this command has successfully completed, this message appears.
rlghncxa03w 06-10-12 09:12:36 GMT EAGLE5 36.0.0
Deactivate Link message sent to card
9. Change the SCTP checksum option in the database using the chg-sg-opts command. For this
example, enter this command.
chg-sg-opts:sctpcsum=crc32c
When this command has successfully completed, the following message should appear.
rlghncxa03w 06-10-28 21:19:37 GMT EAGLE5 36.0.0
CHG-SG-OPTS: MASP A - COMPLTD
Continue the procedure by performing one of these actions.
If the sctpcsum parameter value was changed to either adler32 or crc32c, continue the
procedure with
If the sctpcsum parameter value was changed to percard, perform the
procedure to assign an sctpcsum parameter value to all the cards running the IPLIM or IPLIMI
applications. After the
procedure with
10. Verify that the SCTP checksum algorithm was changed using the rtrv-sg-opts command. The
SCTP checksum algorithm option value is shown in the SCTPCSUM parameter. The following is an
example of the possible output.
rlghncxa03w 06-10-28 21:16:37 GMT EAGLE5 36.0.0
SCTPCSUM:
The rtrv-sg-opts command output contains other fields that are not used by this procedure. If
you wish to see all the fields displayed by the rtrv-sg-opts command, see the rtrv-sg-opts
command description in the Commands Manual.
910-6278-001 Revision A, January 2012
4294967295
4294967295
4294967295
4294967295
4294967295
4294967295
4294967295
4294967295
4294967295
Step 10.
Configuring an IP Card
Step 11.
crc32c
IPSG M2PA and M3UA Configuration Procedures
normalization error
invalid traffic type
M3UA conversion error
SUA conversion error
procedure has been performed, continue the
4294967295
4294967295
4294967295
4294967295
Step
Configuring an IP Card
997
6.