Tekelec IP7 Secure Gateway Administration Manual page 1001

Database Administration Manual - IP7 Secure
Gateway
If the checksum algorithm shown in all of the associations displayed in this step match the checksum
algorithm specified in
14. At the IP near end node, configure all the associations attached to the IP card specified in
to use the SCTP checksum algorithm.
15. Put the signaling link that was placed out of service in
command. For example, enter this command.
act-slk:loc=1315:link=a
When this command has successfully completed, this message appears.
rlghncxa03w 06-10-07 11:11:28 GMT EAGLE5 36.0.0
Activate Link message sent to card
16. Verify the in-service normal (IS-NR) status of the signaling link by using the rept-stat-slk
command and specifying the card location and link value specified in
this command.
rept-stat-slk:loc=1315:link=a
The following is an example of the possible output.
rlghncxa03w 06-10-28 21:16:37 GMT EAGLE5 36.0.0
SLK LSN
1315,A ipgtwy1
Command Completed.
17. At the IP near end node, connect one of the associations attached to the IP card specified in
11.
18. At the EAGLE 5 ISS, enter the rept-stat-assoc command specifying the association names
specified with the chg-assoc command in
established with the IP near end node. For this example, enter this command.
rept-stat-assoc:aname=assoc3
The following is an example of the possible output.
rlghncxa03w 06-10-28 21:16:37 GMT EAGLE5 36.0.0
ANAME
as1
LSN
lpgtwy1
Command Completed.
19. Enter the netstat -p sctp pass command with the card location of the IP card to determine if
any errors have occurred. For this example, enter this command. For this example, enter this
command.
pass:loc=1315:cmd= netstat -p sctp
The following is an example of the possible output.
rlghncxa03w 08-04-28 21:16:37 GMT EAGLE5 38.0.0
ip packets sent...................................... 1474882
ip packets sent with data chunk.................. 306354
910-6278-001 Revision A, January 2012
Step 9, continue the procedure with
CLLI PST
----------- IS-NR
CARD IPLNK
LOC PORT LINK PST
1315 A A
ANAME ASP STATE
assoc3 ACTIVE
IPSG M2PA and M3UA Configuration Procedures
Step 14.
Step 7 back into service using the act-slk
SST
Avail
Step 11 Step 12
and to verify that the association is
SST
IS-NR ESTABLISHED
Step 12
Step 15. For example, enter
AST
----
ASPID
undefined
Step
1001