Tekelec IP7 Secure Gateway Administration Manual page 910

Database Administration Manual - IP7 Secure
Gateway
18. Activate all signaling links that were deactivated in
the card location and link parameter value of each signaling link. For this example, enter this
command.
act-slk:loc=1101:link=a2
act-slk:loc=1101:link=a7
When the act-slk command has successfully completed, this message should appear.
rlghncxa03w 06-10-07 08:31:24 GMT
Activate Link message sent to card
19. Back up the new changes using the chg-db:action=backup:dest=fixed command. These
messages should appear, the active Maintenance and Administration Subsystem Processor (MASP)
appears first.
BACKUP (FIXED) : MASP A - Backup starts on active MASP.
BACKUP (FIXED) : MASP A - Backup on active MASP to fixed disk complete.
BACKUP (FIXED) : MASP A - Backup starts on standby MASP.
BACKUP (FIXED) : MASP A - Backup on standby MASP to fixed disk complete.
If the linkset that was changed in this procedure contained signaling links that were deactivated
when Step 16
If the linkset that was changed in this procedure contained no signaling links when
16
were performed, perform the
signaling links to the linkset.
910-6278-001 Revision A, January 2012
was performed, this procedure is finished.
Adding an IPSG M3UA Signaling Link
IPSG M2PA and M3UA Configuration Procedures
Step 13 using the act-slk command, specifying
EAGLE5 36.0.0
Step 12
procedure to add IPSG M3UA
or Step
910