Figure 90: Removing An End Node Internal Point Code - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway

Figure 90: Removing an End Node Internal Point Code

910-6278-001 Revision A, January 2012
Enter the
rtrv-rmt-appl command
Are the si=3, ssn, or
ssne parameters to be
specified with the
dlt-rmt-appl command?
No
Enter the dlt-rmt-appl command with
these parameters:
:ipc/ipca/ipci/ipcn/ipcn24 = <internal
point code value>
:si = <4 - 15>
Enter the
rtrv-rmt-appl command
Enter the
chg-db:action=backup:dest=fixed
command
Enter the dlt-rmt-appl command with
these mandatory parameters:
:ipc/ipca/ipci/ipcn/ipcn24 = <internal
point code value>
Yes
:si = 3
:ssn = <subsystem number>
and this optional parameter:
:ssne = <SSN value to end a range of
subsystem numbers>
(See Notes 1 and 2)
Notes:
1. The ssn parameter value cannot be greater
than the ssne parameter value.
2. Specifying the ssn and ssne parameters
removes a range of subsystem numbers.
End Office Support
640