Tekelec IP7 Secure Gateway Administration Manual page 959

Database Administration Manual - IP7 Secure
Gateway
PARM 2: ASP/AS Notification options.
PVALUE : Valid range = 32-bits
PARM 3: UA Serviceability Options.
PVALUE : Valid range = 32-bits
PARM 4: SCTP Payload Protocol Indicator byte order option. Bit indicates
PVALUE : Valid range = 32-bits
If you do not wish to change the UA parameter set values, continue the procedure with
If the UA parameter set you wish to assign to the association does not contain the desired values,
Changing a UA Parameter Set
go to the
the UA parameter set values have been changed, continue the procedure with
CAUTION: Changing a UA parameter set may affect the performance of any
associations using the parameter set being changed.
11. Change the association using the chg-assoc command.
For this example, enter this command.
chg-assoc:aname=assoc2:lhost=m2pa2:alhost=m2pa3
Note: See (Sheet 7) for the rules that apply to the chg-assoc command.
These are the rules that apply to changing the host values of an IPSG association.
If any optional parameters are not specified with the chg-assoc command, those values are
not changed.
The EAGLE 5 ISS can contain a maximum of 4000 connections.
The host of an IPSG association can contains a maximum of 32 IPSG associations.
The value of the lhost parameters is a text string of up to 60 characters, with the first character
being a letter. The command input is limited to 150 characters, including the hostnames.
910-6278-001 Revision A, January 2012
0=Broadcast
1=Response Method
2-5=Reserved
6=Broadcast Congestion Status Change 0=Disabled , 1=Enabled
7-31=Reserved
enabled/disabled flag for a particular ASP/AS
Notification option.
BIT
0=ASP Active Notifications
1=ASP Inactive Notifications
2=ASP AS State Query
3-31=Reserved
enabled/disabled flag for a particular UA Serviceability
option. Supported on IPSG, SS7IPGW, and IPGWI applications.
UA Graceful Shutdown supported on IPSG for M3UA only.
BIT
0=UA Heartbeats
1=UA Graceful Shutdown
2-31=Reserved
PPI value is RCV/TX in Big Endian or Little Endian byte format.
Supported on IPSG-M2PA associations only.
BIT
0=Payload Protocol Indicator
1-31=Reserved
procedure and change the desired parameter set values. After
IPSG M2PA and M3UA Configuration Procedures
0=Disabled , 1=Enabled
0=Disabled , 1=Enabled
Each bit is used as an
Not supported on IPSG application.
BIT VALUE
0=Disabled , 1=Enabled
0=Disabled , 1=Enabled
0=Disabled , 1=Enabled
Each bit is used as an
BIT VALUE
0=Disabled , 1=Enabled
0=Disabled , 1=Enabled
BIT VALUE
0=Big Endian , 1=Little Endian
Step 11.
Step 11.
959