Changing The Routing Context Value In An Existing Routing Key; Table 41: Service Indicator Text String Values - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway

Changing the Routing Context Value in an Existing Routing Key

This procedure is used to change the routing context value in an existing routing key using the
chg-appl-rtkey command.
The routing key being changed in this procedure must contain a number for the routing context value.
If the routing context value shown for the routing key contains dashes (-), this routing key cannot be
used in this procedure. The dashes shows that the routing key does not have a routing context assigned
to it.
To assign a routing context value to an existing M3UA routing key, the routing key must be removed
by performing the
the routing key with the routing context value by performing the
Application Server
These parameters are used in this procedure.
:rcontext – The current routing context parameter value, which has two functions:
Provides an index of the application server traffic that the sending ASP is configured or registered
to receive.
Identifies the SS7 network context for the message. The routing context parameter implicitly defines
the SS7 point code format used, the SS7 network indicator value, and the SCCP protocol
type/variant/version used.
:nrcontext – The new routing context parameter value, from 0 to 4294967295. The new routing
context value cannot be assigned to other routing keys.
The chg-appl-rtkey command contains other parameters that are not used in this procedure.
:dpc/dpca/dpci/dpcn/dpcn24 – Destination point code value that is used to filter incoming MSUs.
:opc/opca/opci/opcn/opcn24 - The originating point code value that is used to filter incoming
MSUs. This value must not specify a cluster route.
:si – The service indicator value that is used to filter incoming MSUs. The range of values for the
service indicator parameter (si) can be a numerical value from 0 to 15, or for selected service indicator
values, a text string can be used instead of numbers.
the text strings that can be used in place of numbers for the service indicator values.

Table 41: Service Indicator Text String Values

Service Indicator
Value
0
1
2
3
910-6278-001 Revision A, January 2012
Removing a Routing Key Containing an Application Server
procedure. A routing context value must always be assigned to an SUA routing key.
Text String
snm
regtest
spltst
sccp
IETF M3UA and SUA Configuration Procedures
Adding a Routing Key Containing an
Table 41: Service Indicator Text String Values
Service Indicator Value
4
5
13
procedure, then re-enter
shows
Text String
tup
isup
qbicc
581