Tekelec IP7 Secure Gateway Administration Manual page 1037

Database Administration Manual - IP7 Secure
Gateway
GPL CARD
HIPR2 1109
HIPR2 1110
HIPR2 1209
HIPR2 1210
HIPR2 1309
HIPR2 1310
HIPR2 2109
HIPR2 2110
Command Completed
If HIPR2 cards are installed at the card locations 9 and 10 on the shelf where the E5-SLAN card is
to be installed, continue the procedure with
If HIPR or HIPR2 cards are not installed at the card locations 9 and 10 on the shelf where the
E5-SLAN card is to be installed, refer to the Installation Manual - EAGLE 5 ISS to install the HIPR
or HIPR2 cards. Once the HIPR or HIPR2 cards have been installed, continue the procedure with
Step 8.
8. Before the 2000 or 2800 signaling link quantity can be enabled, make sure the EAGLE 5 ISS is
configured with the hardware shown in the
than 2000"
section.
If hardware other than the hardware shown in the
Greater than 2000"
enabling the 2000 or 2800 signaling link quantity. Refer to
information.
9. Enable the Large System # Links controlled feature for the desired quantity with the
enable-ctrl-feat command specifying the part number corresponding to the new quantity of
signaling links and the feature access key.
To increase the number of signaling links the EAGLE 5 ISS can contain to 1500, enter this command.
enable-ctrl-feat:partnum=893005901:fak=<feature access key>
To increase the number of signaling links the EAGLE 5 ISS can contain to 2000, enter this command.
enable-ctrl-feat:partnum=893005910:fak=<feature access key>
To increase the number of signaling links the EAGLE 5 ISS can contain to 2800, enter this command.
enable-ctrl-feat:partnum=893005911:fak=<feature access key>
Note: A temporary feature access key cannot be specified to enable this feature.
Note: The values for the feature access key (the fak parameter) are provided by Tekelec. If you
do not have the feature access key for the feature you wish to enable, contact your Tekelec Sales
Representative or Account Representative.
When the enable-crtl-feat command has successfully completed, this message should appear.
rlghncxa03w 06-10-28 21:15:37 GMT EAGLE5 36.0.0
ENABLE-CTRL-FEAT: MASP B - COMPLTD
10. Verify the changes by entering the rtrv-ctrl-featcommand with the part number specified
Step 9.
in
If the 1500 signaling link quantity was enabled in
rtrv-ctrl-feat:partnum=893005901
910-6278-001 Revision A, January 2012
RUNNING
132-002-000
132-002-000
132-002-000
132-002-000
132-002-000
132-002-000
132-002-000
132-002-000
section is installed and provisioned, contact the Customer Care Center before
APPROVED
132-002-000
132-002-000
132-002-000
132-002-000
132-002-000
132-002-000
132-002-000
132-002-000
Step 8.
"Hardware Supported for Signaling Link Quantities Greater
"Hardware Supported for Signaling Link Quantities
Customer Care Center
Step 9, enter this command.
Reference Information
TRIAL
132-003-000
132-003-000
132-003-000
132-003-000
132-003-000
132-003-000
132-003-000
132-003-000
for the contact
1037