Figure 123: Changing An M2Pa Timer Set - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
BACKUP (FIXED) : MASP A - Backup on active MASP to fixed disk complete.
BACKUP (FIXED) : MASP A - Backup starts on standby MASP.
BACKUP (FIXED) : MASP A - Backup on standby MASP to fixed disk complete.

Figure 123: Changing an M2PA Timer Set

910-6278-001 Revision A, January 2012
Enter the
rtrv-m2pa-tset command with one of these
parameters:
:ver = d6 - to display the Draft 6 values
:ver = rfc - to display the RFC values.
If the ver parameter is not specified with the
rtrv-m2pa-tset command, both the Draft 6 and
RFC values will be displayed.
Is an M2PA timer set
to be copied to another
M2PA timer set ?
No
Enter the
chg-m2pa-tset command with
these parameters:
:tset=<the number of the M2PA
timer set being changed>
:ver=<version of the M2PA timer
set being changed, either d6 (Draft
6 version) or rfc (RFC version)>
and at least one of the timer
parameters shown in the M2PA
Timers table in this procedure.
The values for the M2PA timers
are shown in the M2PA Timers
table in this procedure.
(See Caution and Note)
Notes:
1. Either the timer parameters or the srctset parameter must be specified with the
chg-m2pa-tset command. Both the timer parameters and the srctset parameter
cannot be specified with the chg-m2pa-tset command.
2. If the ver parameter is not specified with the chg-m2pa-tset command, the RFC
values will be changed. To change the Draft 6 values, the ver=d6 parameter must be
specified with the chg-m2pa-tset command.
Caution: Changing an M2PA timer set may affect the performance of any
associations using the timer set being changed.
IPSG M2PA and M3UA Configuration Procedures
Enter the
chg-m2pa-tset command with only
these parameters:
:tset=<the number of the M2PA
Yes timer set being changed>
:srctset=<the number of the M2PA
timer set being copied>
:ver=<version of the M2PA timer
set being copied, either d6 (Draft 6
version) or rfc (RFC version)>
(See Caution and Note)
Enter the
rtrv-m2pa-tset command with these
parameters:
:tset=<tset value specified in the
chg-m2pa-tset command>
:ver=<version of the M2PA timer set
specified in the chg-m2pa-tset
command>
Enter the
chg-db:action=backup:dest=fixed
command
1015