Tekelec IP7 Secure Gateway Administration Manual page 835

Database Administration Manual - IP7 Secure
Gateway
The dlt-assoc command uses one parameter, aname, the name of the association being removed
from the database. The association being removed must be in the database.
The open parameter must be set to no before the association can be removed. Use the chg-assoc
command to change the value of the open parameter.
The adapter value assigned to the association being removed in this procedure must be either m2pa
or m3ua. The application assigned to the card that is hosting the association must be IPSG.
If the adapter value of the association is m2pa and the application assigned to the card is either IPLIM
or IPLIMI (an IPLIMx card), perform the
assigned to an IPLIMx card.
If the adapter value of the association is m3ua and the application assigned to the card is either
SS7IPGW or IPGWI (an IPGWx card), perform the
M3UA association assigned to an IPGWx card.
Canceling the RTRV-ASSOC Command
Because the rtrv-assoc command used in this procedure can output information for a long period
of time, the rtrv-assoc command can be canceled and the output to the terminal stopped. There
are three ways that the rtrv-assoc command can be canceled.
Press the F9 function key on the keyboard at the terminal where the rtrv-assoc command was
entered.
Enter the canc-cmd without the trm parameter at the terminal where the rtrv-assoc command
was entered.
Enter the canc-cmd:trm=<xx>, where <xx> is the terminal where the rtrv-assoc command
was entered, from another terminal other that the terminal where the rtrv-assoc command was
entered. To enter the canc-cmd:trm=<xx> command, the terminal must allow Security
Administration commands to be entered from it and the user must be allowed to enter Security
Administration commands. The terminal's permissions can be verified with the rtrv-secu-trm
command. The user's permissions can be verified with the rtrv-user or rtrv-secu-user
commands.
For more information about the canc-cmd command, go to the Commands Manual.
1. Display the associations in the database using the rtrv-assoc command.
This is an example of possible output.
rlghncxa03w 06-10-28 09:12:36 GMT EAGLE5 36.0.0
ANAME
swbel32
a2
a3
assoc1
Select an association whose ADAPTER value is either M3UA or M2PA.
2. Enter the rtrv-card command with the location of the card that is hosting the association that
will be removed in this procedure. For this example, enter these commands.
rtrv-card:loc=1201
910-6278-001 Revision A, January 2012
Removing an M2PA Association
CARD IPLNK
LOC PORT LINK ADAPTER LPORT RPORT OPEN ALW
1201 A A M3UA
1305 A A SUA
1307 A A SUA
1203 A A1 M2PA
IPSG M2PA and M3UA Configuration Procedures
to remove an M2PA association
Removing a M3UA or SUA Association
1030 2345 YES
1030 2345 YES
1030 2346 YES
2048 1030 NO
to remove an
YES
YES
YES
NO
835