Figure 109: Removing An Ipsg M2Pa Signaling Link - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
From
Sheet 1
Enter the rmv-card command with
:loc=<location of the signaling link>
Enter the rept-stat-card command
with this parameter.
:loc=<location of the signaling link>
Enter the dlt-slk command with
these parameters.
:loc=<location of the signaling link>
:link=<signaling link being
removed>
:force=yes
See the Note.
Sheet 2 of 2

Figure 109: Removing an IPSG M2PA Signaling Link

910-6278-001 Revision A, January 2012
Is the host name
assigned to any inservice
or open associations?
Yes
Enter the chg-assoc
:aname=<association name>
:open=no:alw=no command
Repeat this step for all
associations shown in the
rtrv-assoc output whose open or
alw parameter values are yes.
this parameter.
Is the signaling
Yes
link the last signaling
link in the linkset?
Enter the dlt-slk command with
these parameters.
:loc=<location of the signaling link>
:link=<signaling link being
removed>
See the Note.
Enter the rtrv-slk command with these
parameters.
:loc=<location specified in the dlt-slk
command>
:link=<signaling link specified in the dlt-slk
command>
IPSG M2PA and M3UA Configuration Procedures
No
Enter the dact-slk command with
these parameters.
:loc=<location of the signaling link>
:link=<signaling link being
removed>
Enter the rept-stat-slk command
with these parameters.
:loc=<location of the signaling link>
:link=<signaling link being
removed>
Is the signaling
Yes
link the last signaling
link on the card?
No
No
Note: If removing the signaling link
will result in 700 or less signaling
links in the database and the
OAMHCMEAS value in the
rtrv-measopts output is on, the
scheduled UI measurement reports
chg-db:action=backup:dest=fixed
will be enabled.
Enter the
command.
847