Tekelec IP7 Secure Gateway Administration Manual page 531

Database Administration Manual - IP7 Secure
Gateway
Enter the canc-cmd:trm=<xx>, where <xx> is the terminal where the rtrv-assoc command
was entered, from another terminal other that the terminal where the rtrv-assoc command was
entered. To enter the canc-cmd:trm=<xx> command, the terminal must allow Security
Administration commands to be entered from it and the user must be allowed to enter Security
Administration commands. The terminal's permissions can be verified with the rtrv-secu-trm
command. The user's permissions can be verified with the rtrv-user or rtrv-secu-user
commands.
For more information about the canc-cmd command, go to the Commands Manual.
1. Display the associations in the database using the rtrv-assoc command.
This is an example of possible output.
rlghncxa03w 08-04-28 09:12:36 GMT EAGLE5 38.0.0
ANAME
swbel32
a2
a3
assoc1
assoc2
assoc3
assoc5
Select an association whose adapter value is M3UA or SUA. If the card shown in the CARD LOC
column contains any SUA associations, and the open parameter value of the association is no,
continue the procedure with
the procedure with
If the card contains only M3UA associations, continue the procedure with
2. Enter the rtrv-card command with the location of the card that is hosting the M3UA association
that will be changed in this procedure. For this example, enter this command.
rtrv-card:loc=1205
This is an example of possible output.
rlghncxa03w 08-04-06 15:17:20 EST EAGLE5 38.0.0
CARD TYPE
1205 DCM
If the application assigned to the card is SS7IPGW or IPGWI, shown in the APPL column, continue
the procedure by performing one of these steps.
If the open parameter value for the association being changed is yes, continue the procedure
with Step 3.
If the open parameter value for the association being changed is no, continue the procedure
with Step 4.
If the application assigned to the card is IPSG, perform the
Association procedure.
3. Change the value of the open parameter to no by specifying the chg-assoc command with the
open=no parameter.
For this example, enter this command.
chg-assoc:aname=assoc2:open=no
910-6278-001 Revision A, January 2012
CARD IPLNK
LOC PORT LINK ADAPTER LPORT RPORT OPEN ALW
1201 A A M3UA
1305 A A SUA
1307 A A SUA
1201 A A M3UA
1205 A A M3UA
1205 A A M3UA
1205 A A M3UA
Step 4. If the open parameter value of the association is yes, continue
Step 3
APPL LSET NAME
SS7IPGW e5e6a
IETF M3UA and SUA Configuration Procedures
1030 2345 YES
1030 2345 YES
1030 2346 YES
2000 1030 YES
2048 2048 YES
3000 3000 YES
1500 3000 YES
LINK SLC LSET NAME
A 0
Changing the Buffer Size of an IPSG
YES
YES
YES
YES
YES
YES
YES
Step 2.
LINK SLC
531