Figure 102: Adding A Network Appearance - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
ent-na command with these mandatory
:na=<0 - 4294967295>
:type = <ansi, itui, itun, itun24, ituis, ituns>
and this optional parameter:
:gc = <group code for 14-bit ITU-N point
codes or 14-bit ITU-N spare point codes>
(See Notes 1 through 4)
rtrv-na command
chg-db:action=backup:dest=fixed
Sheet 3 of 3

Figure 102: Adding a Network Appearance

910-6278-001 Revision A, January 2012
From
Sheet 2
Notes:
Enter the
1. The group code value (gc) must be shown in
parameters: the rtrv-sid or rtrv-spc output.
2. The gc parameter can be specified with the
type=itun or type=ituns parameters, but cannot
be specified with the type=ansi, type=itui,
type=ituis or type=itun24 parameters.
3. If group codes are shown in the rtrv-sid or
rtrv-spc outputs, the gc parameter must be
specified with the type=itun or type=ituns
parameters.
4. The type=ituis or type=ituns parameters can
Enter the
be specified only if the ITU National and
International Spare Point Code Support feature
is enabled.
Enter the
command
IPSG M2PA and M3UA Configuration Procedures
800