Figure 95: Adding An Ip Host - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
BACKUP (FIXED) : MASP A - Backup starts on standby MASP.
BACKUP (FIXED) : MASP A - Backup on standby MASP to fixed disk complete.
Enter the rtrv-ip-host
command with this
parameter.
:display=all
Enter the rtrv-ip-lnk
command
Is a local
host being
configured?
Is the IP address
for this local host shown in
the rtrv-ip-lnk output?

Figure 95: Adding an IP Host

910-6278-001 Revision A, January 2012
Enter the ent-ip-host command with
these parameters:
:host = <the hostname to be associated
with the IP address>
No :ipaddr = <IP address to be associated
with the hostname>
The IP address assigned to the remote
host cannot be shown in the rtrv-ip-lnk
Yes
Perform the Changing an IP
No
Link" procedure in this chapter
to add the IP address.
Yes
Enter the ent-ip-host command with
these mandatory parameters:
:host = <the hostname to be associated
with the IP address>
:ipaddr = <IP address to be associated
with the hostname>
and with this optional parameter:
Enter the rtrv-ip-host command
with this parameter:
:host = <the hostname specified
in the ent-ip-host command>
chg-db:action=backup:dest=fixed
IPSG M2PA and M3UA Configuration Procedures
:type=remote
output.
:type=local
Enter the
command
712