Changing Ietf M2Pa Components; Figure 34: Removing An M2Pa Association - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
Enter the rtrv-assoc
command
The adapter value assigned to the
association must be m2pa.
What is the
value of the open
parameter?

Figure 34: Removing an M2PA Association

Changing IETF M2PA Components

This section describes how to change the attributes of the following components in the database.
910-6278-001 Revision A, January 2012
Enter the rtrv-card command
with this parameter:
:loc = <the location of the card
containing the M2PA association that is
shown in the rtrv-assoc output>
IPLIM,
IPLIMI
What application is
assigned to the card?
Perform the "Removing an
procedure to remove the
Enter the chg-assoc command with
these parameters:
Yes
:aname=<the name of the M2PA
No
Enter the dlt-assoc command
with this parameter:
:aname = <name of the M2PA
Enter the rtrv-assoc command with
this parameter:
:aname = <association name
specified in the dlt-assoc command>
chg-db:action=backup:dest=fixed
IETF M2PA Configuration Procedures
IPSG
IPSG Association"
M2PA association .
association>
:open=no
association>
Enter the
command
178