Tekelec IP7 Secure Gateway Administration Manual page 715

Database Administration Manual - IP7 Secure
Gateway
BPIPADDR
BPSUBMASK ---------------
To change the parameters of an IP card, the signaling link to the card and the card have to be
inhibited.
2. Display the signaling link associated with the card shown in
specifying the card location.
For this example, enter this command.
rtrv-slk:loc=1201
This is an example of the possible output.
rlghncxa03w 08-04-12 15:36:20 GMT
LOC LINK LSN
1201 A nc001
IPTPS for LOC = 1102 is (1015 of 5000) 20%
3. Retrieve the status of the signaling link shown in
specifying the card location and signaling link.
For example, enter this command.
rept-stat-slk:loc=1201:link=a
The output lists the signaling link assigned to this card:
rlghncxa03w 06-10-28 21:16:37 GMT EAGLE5 36.0.0
SLK LSN
1201,A nc001
Avail
Command Completed.
If the signaling link is in service-normal (IS-NR), continue the procedure with
the signaling link. If the signaling link is out-of-service-maintenance disabled (OOS-MT-DSBLD),
continue the procedure with
4. Deactivate the signaling link assigned to the IP card using the rept-stat-slk command.
For example, enter this command.
dact-slk:loc=1201:link=a
CAUTION: This command impacts network performance and should only be used
during periods of low traffic.
After this command has successfully completed, this message appears.
rlghncxa03w 06-10-12 09:12:36 GMT EAGLE5 36.0.0
Deactivate Link message sent to card.
5. Verify the new link status using the rept-stat-slk command.
For example, enter this command.
rept-stat-slk:loc=1201:link=a
910-6278-001 Revision A, January 2012
---------------
SLC TYPE
0 IPSG
CLLI PST
-----------
----
Step 6 to verify the card status.
IPSG M2PA and M3UA Configuration Procedures
Step 1
38.0.0
ANAME SLKTPS
m2pa1 1015
Step 2 using the rept-stat-slk command
SST
IS-NR
using the rtrv-slk command
AST
Step 4 to deactivate
715