Tekelec IP7 Secure Gateway Administration Manual page 891

Database Administration Manual - IP7 Secure
Gateway
From
Sheet 1
500,000
Do you wish
to change the maximum
total provisioned system
TPS value?
Yes
Perform the Activating the
HIPR2 High Rate Mode Feature"
procedure to enable and turn on
the HIPR2 High Rate Mode
feature. When the HIPR2 High
Rate Mode feature is enabled
and turned on, the maximum
total provisioned system TPS
value is increased to 750,000.
To
Sheet 5
Sheet 2 of 5
910-6278-001 Revision A, January 2012
Enter the rtrv-tps
command.
Will the
RSVDSLKTPS or the
MAXSLKTPS values exceed the
maximum total provisioned
system TPS?
Yes
What is
the maximum total
750,000
provisioned system TPS
value? See
the Note.
To add the signaling link , one or more of these actions
The IP TPS values of some IPGWx linksets will have
to be changed.
The MAXSLKTPS values of some IPSG linksets (and
the RSVDSLKTPS values if necessary) will have to
No
be changed.
Some ATM high -speed signaling links will have to be
removed. An ANSI ATM high -speed signaling link
uses 1630 TPS. An ITU ATM high -speed signaling
link uses 2038 TPS.
Remove an IPLIMx card that contains signaling links.
An IPLIMx card that contains signaling links uses
4000 TPS.
IPSG M2PA and M3UA Configuration Procedures
No
To
Sheet 5
Note: The maximum total
provisioned system TPS
cannot be increased
beyond 750,000 TPS.
must be performed.
To
Sheet 3
891