Tekelec IP7 Secure Gateway Administration Manual page 1011

Database Administration Manual - IP7 Secure
Gateway
Timer Draft 6
Timer
Name
Remote Congestion
:t6
Excess Delay in
Acknowledgement
:t7
Proving Rate Timer
:t16
Ready Rate Timer
:t17
Processor Outage Rate
:t18
msecs - milliseconds
* The T2 Timer can be specified only for the M2PA RFC version.
** The value of the T16 Timer is in microseconds.
The value of any timer parameter not specified with the chg-m2pa-tset command is not changed.
1. Display the M2PA timer sets in the database by entering the rtrv-m2pa-tset command with
the version of the M2PA timer sets you wish to change with the ver parameter.
To display the M2PA Draft 6 timer values, enter this command.
rtrv-m2pa-tset:ver=d6
rlghncxa03w 06-10-28 21:16:37 GMT EAGLE5 36.0.0
910-6278-001 Revision A, January 2012
RFC
Timer
Name
The amount of time that a
congested link will remain in
Timer
service.
The maximum amount of time
that may pass between when a
user data message is
transmitted and an
acknowledgement for that
Timer message is received from the
peer. If this timer expires, the
link is taken out of service.
The amount of time between
sending Link Status Proving
messages while the T4N or T4E
timer is running.
The amount of time between
sending Link Status Ready
messages while the T3 timer is
running.
The amount of time between
sending Link Status Processor
Timer Outage messages while the link
is in-service.
IPSG M2PA and M3UA Configuration Procedures
Definition
1000 - 6000
100 - 10000
Value (in DRAFT 6
msecs) System
Default
Value (in
msecs)
3000
200 - 2000 1200
100 -
200000 **
500000 **
100 - 500 250
1000
RFC
System
Default
Value (in
msecs)
3000
1200
200000 **
250
1000
1011