Table 54: Ipsg M2Pa Signaling Link Parameter Combinations - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
IP Appl Sock/Assoc table is (7 of 4000) 1% full
Assoc Buffer Space Used (1400 KB of 6400 KB) on LOC = 2204
Associations that can be assigned to an IPSG M2PA signaling link cannot be assigned to a signaling
link shown by dashes in the LINK column, and the ADAPTER value of the association must be
M2PA. If the associations displayed in this step do not meet these requirements, add the IPSG
M2PA association by performing the
association has been added, continue the procedure with
If the associations displayed in this step meet these requirements, continue the procedure with
12.
12. Add the signaling link to the database using the ent-slk command.

Table 54: IPSG M2PA Signaling Link Parameter Combinations

can be specified with the ent-slk command.
Table 54: IPSG M2PA Signaling Link Parameter Combinations
:loc = location of the IPSG card
:link = a - a15, b - b15
:lsn = linkset name
:slc = 0 - 15
:aname = the name of the IPSG M2PA association
For this example, enter this command.
ent-slk:loc=2204:link=a10:lsn=lsipgw:slc=1:aname=m2pa3
When this command has successfully completed, this message should appear.
rlghncxa03w 06-10-07 08:29:03 GMT
ENT-SLK: MASP A - COMPLTD
Note: If adding the new signaling link will result in more than 700 signaling links in the database
and the OAMHCMEAS value in the rtrv-measopts output is on, the scheduled UI measurement
reports will be disabled.
13. Verify the changes using the rtrv-slk command with the card location and link parameter
values specified in
rtrv-slk:loc=2204:link=a10
This is an example of the possible output.
rlghncxa03w 06-10-19 21:16:37 GMT EAGLE5 36.0.0
LOC LINK LSN
2204 A10 lsipgw
14. If any cards contain the first signaling link on a card, those cards must be brought into service with
the rst-card command, specifying the location of the card. For this example, enter this command.
910-6278-001 Revision A, January 2012
Adding an IPSG M2PA Association
IPSG M2PA Signaling Link
Mandatory Parameters
Step 12. For this example, enter these commands.
SLC TYPE
1 IPSG
IPSG M2PA and M3UA Configuration Procedures
Step 12.
shows the parameters and values that
EAGLE5 36.0.0
ANAME SLKTPS
m2pa3 500
procedure. After the
Step
763