Configuring A Static Ipv6 Route; Configuring Ipv6 Tcp Properties - H3C S3100 Series Operation Manual

Table 1-10 Configure the neighbor reachable timeout time on an interface
To do...
Enter system view
Enter VLAN interface view
Configure the neighbor reachable
timeout time

Configuring a Static IPv6 Route

You can configure static IPv6 routes for network interconnection in a small sized IPv6 network.
Table 1-11 Configure a static IPv6 route
To do...
Enter system view
Configure a static IPv6
route

Configuring IPv6 TCP Properties

The IPv6 TCP properties you can configure include:
synwait timer: When a SYN packet is sent, the synwait timer is triggered. If no response packet is
received before the synwait timer expires, the IPv6 TCP connection establishment fails.
finwait timer: When the IPv6 TCP connection status is FIN_WAIT_2, the finwait timer is triggered. If
no packet is received before the finwait timer expires, the IPv6 TCP connection is terminated. If FIN
packets are received, the IPv6 TCP connection status becomes TIME_WAIT. If other packets are
received, the finwait timer is reset from the last packet and the connection is terminated after the
finwait timer expires.
Size of IPv6 TCP receiving/sending buffer.
Table 1-12 Configure IPv6 TCP properties
To do...
Enter system view
Set the finwait timer of IPv6 TCP
packets
Set the synwait timer of IPv6 TCP
packets
Configure the size of IPv6 TCP
receiving/sending buffer
Use the command...
system-view
interface interface-type
interface-number
ipv6 nd nud reachable-time
value
Use the command...
system-view
ipv6 route-static ipv6-address
prefix-length [ interface-type
interface-number] nexthop-address
Use the command...
system-view
tcp ipv6 timer fin-timeout
wait-time
tcp ipv6 timer syn-timeout
wait-time
tcp ipv6 window size
1-17
Remarks
—
—
Optional
30,000 milliseconds
Remarks
—
Required
By default, no static IPv6 route is
configured.
Remarks
—
Optional
675 seconds by default
Optional
75 seconds by default
Optional
8 KB by default