Clear Ip Ospf Neighbor - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
clear ip ospf neighbor
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
clear ip ospf neighbor [ neighborAddress ]
Command introduced in JunosE Release 7.1.0.
Clears or resets adjacency with a specified neighbor session. There is no no version.
NOTE: When OSPF is configured and running over an NBMA network, do not issue the
clear ip ospf neighbor command simultaneously on both ends of the OSPF link. Doing
so brings the OSPF link down completely. In this event, you must do one of the following
on both sides of the link to bring the link back up:
Reconfigure the OSPF neighbors on the NBMA interface with the neighbor command.
Issue the clear ip ospf database command to clear and reset the OSPF adjacencies.
Issue the shutdown command followed by the no shutdown command on the
interface.
neighborAddress—IP address of identified neighbor to clear or reset
Privileged Exec
Chapter 4: C Commands
391
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers