Bridge Vpls Site-Range - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

bridge vpls site-range

Syntax
Release Information
Description
Options
Mode
Related Topics
Copyright © 2010, Juniper Networks, Inc.
bridge vplsName vpls site-range siteRange
no bridge vplsName vpls site-range
Command introduced in JunosE Release 7.1.0.
Configures the maximum number of customer sites that can participate in the specified
VPLS domain that uses BGP as the signaling protocol. In a VPLS configuration, each
customer site is represented by a customer edge (CE) device located at the edge of the
customer's network. The router (VPLS edge device) communicates with the customer
site by means of a bridge network interface connection to the CE device. The no version
restores the default site range, 1.
The bridge vpls site-range command is not valid for a VPLS instance that uses LDP as
the signaling protocol. To configure a VPLS instance with LDP signaling, use the mpls
ldp vpls vpls-id command and the mpls ldp vpls neighbor command.
NOTE: The bridge vpls site-range command is available for a VPLS instance only after
you issue the bridge vpls transport-virtual-router command, which creates the VPLS
instance and configures the transport virtual router.
vplsName—Name of a VPLS instance created with the bridge vpls
transport-virtual-router command
siteRange—Maximum number of sites that can participate in the VPLS domain, in the
range 1–65534; default value is 1
Global Configuration
Configuring VPLS Instances with BGP Signaling in the JunosE BGP and MPLS Configuration
Guide
Chapter 3: B Commands
325