Bridge Crb - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

bridge crb

Syntax
Release Information
Description
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] bridge crb
Command introduced before JunosE Release 7.1.0.
Enables concurrent routing and bridging (CRB) for all bridge groups configured on the
router except those bridge groups configured as VPLS instances. When CRB is enabled,
the router can route a protocol among a group of interfaces in one bridge group and
concurrently bridge the same protocol among a separate group of interfaces in a different
bridge group on the router. The no version disables CRB on all bridge groups and restores
the default bridging capability.
The command takes effect for all bridge groups on the router not configured as VPLS
instances; you cannot enable CRB for some bridge groups but not for others.
Global Configuration
Chapter 3: B Commands
315