Address Hello-Interval - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

address hello-interval

Syntax
Release Information
Description
Options
Mode
96
[ no ] address { ipAddress | unnumbered interfaceType interfaceSpecifier }
hello-interval helloInterval
Command introduced before JunosE Release 7.1.0.
Specifies the interval between hello packets that the router sends on the interface. The
no version resets the hello interval to its default.
NOTE: You must issue the address area command before issuing this
command.
ipAddress—OSPF interface address previously specified with the address command
unnumbered—Indicates that OSPF is running on an unnumbered interface previously
specified with the address command
interfaceType—Interface type; see "Interface Types and Specifiers" on page 5
interfaceSpecifier—Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
helloInterval—Number in the range 1–65535 seconds; default value is 10 seconds
Router Configuration
Copyright © 2010, Juniper Networks, Inc.