Display Dialer - H3C MSR810 Command Reference Manual

Examples
# Create dialer group 1 and configure DDR to place calls for IPv4 packets. Associate Serial 2/1/0
with dialer group 1.
<Sysname> system-view
[Sysname] dialer-group 1 rule ip permit
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] dialer-group 1
# Create dialer group 1 and configure DDR to place calls for IPv6 packets. Associate Serial 2/1/0
with dialer group 1.
<Sysname> system-view
[Sysname] dialer-group 1 rule ipv6 permit
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] dialer-group 1
Related commands
dialer-group

display dialer

Use display dialer to display the DDR information for an interface.
Syntax
display dialer [ interface interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface interface-type interface-number: Specifies an interface by its type and number. If you do
not specify an interface, this command displays the DDR information for all interfaces.
Examples
# Display the DDR information for all interfaces.
<Sysname> display dialer
Dialer0:
Dialer Route:
NextHop: 111.111.111.111
NextHop: 222.222.222.222
Dialer number:
Dialer Timers(in seconds):
Auto-dial: 300
Idle: 120
Total Channels: 1
Free Channels: 1
Dialer number: 123456789012345678901234567890
Dialer number: 123456789012345678901234567890
Compete: 20
Wait-for-Carrier: 60
305
Enable: 5