New Holland T8010 Manual page 1141

Hide thumbs Also See for T8010:

Table of Contents

Dipstick Method

When all refrigerant has been recovered, remove the

oil filler plug.

socket to remove the three screws, and

remove the dust cover from the clutch. Use a wrench

to rotate the compressor shaft clockwise until the

internal parts are in a position to allow dipstick

ALTERNATE METHOD: Use a jumper wire to supply

12V B+ to the compressor clutch and rotate by hand.

Put the dipstick in the oil filler hole to the stop

position. Make sure the dipstick is inserted all the

way to the stop. The dipstick stop should be flush

with the filler hole boss.

Take several readings for accuracy. The oil level

should cover five lines on the dipstick.

NOTE: The illustration shows a front view of the

compressor with the dust cover removed and the

proper positions of the counterweight for insertion of

the dipstick.

IMPORTANT: When compressor is replaced, the old

compressor oil should be drained and the oil volume

measured. This amount of new oil should be put into

the replacement compressor after it has been

drained. Or use the dipstick to measure and match

the replacement compressor oil level to the old

compressor oil level.

Section 50 - Climate Control - Chapter 2

Chapters

Table of Contents

T8020 T8030 T8040