Receiver-Drier - New Holland T8010 Manual

STEP 148
Remove the upper and lower bolts (1) of the
condenser/fuel cooler to replace the unit.
NOTE: Hydraulic cooling line (2) shown removed,
dose not need to be removed for this procedure.
STEP 149
When installing a new condenser, also install new O-rings
on the A/C lines before connecting. Lubricate the O-rings
with clean mineral oil prior to installation.
Use the two hand, two wrench method when
connecting the line from the compressor and to the

receiver-drier.

Receiver-Drier
STEP 150
Replace the receiver-drier if:
A. System has been opened before.
B. Receiver-drier has been used two or more
years.
C. Disassembly show small particles of moisture
removing material (gold or brown particles).
D. If the system has been open for a long period
of time because of a leak (broken hoses, loose
c o nn e c t i on ) t h a t h a s pe r mi t t ed a i r a n d
moisture to enter the system.
E. If contaminated refrigerant was recovered from
the system.
The receiver-drier orientation is critical. Make sure
the outlet flange is within 5 degrees of true level (the
decal should face up).
The receiver-drier must be installed with the inlet
connected to the hose from the condenser and the
outlet connected to the hose going to the thermal
expansion valve.
The receiver-drier is normally the last item replaced
when servicing the system, just before the system is
evacuated. This prevents saturating the drier with
moisture.
Section 50 - Climate Control - Chapter 2
50-2-88
1
2
RD05N017
RD06A172
RD05N020