New Holland T8010 Manual page 1086

STEP 35
If a recovery tank becomes full during a recovery, the
float switch will automatically turn off the station. To
change a full tank in the middle of a recovery:
A. Close the blue tank valve and the valve on the
black hose from the station.
B. Unscrew and remove the float cable from the
tank.
C. Disconnect the hose from the tank valve.
D. Remove the tank from the station.
E. Replace the tank with a properly prepared tank
(dry nitrogen charge released and vacuum
drawn and held for five minutes).
F. Connect the tank valve hose and the float
cable.
G. Open the tank valve and the tank hose valve.
Recovery will continue as soon as both valves
are open.
IMPORTANT: Do not use recovered contaminated
refrigerant in any A/C system. Send full tanks to a
reclamation center for purifying or disposal of the
contents.
STEP 36
All refrigerant has been removed from the A/C
system, replace components or make any repairs at
this time.
IMPORTANT: Replace the receiver-drier on the
tractor being ser viced before you evacuate or
recharge the system with OEM1415 or OEM1418.
STEP 37
See evacuation and recharging in this Section to
recharge the A/C system with pure R134a refrigerant
using OEM1415 or OEM1418.
Section 50 - Climate Control - Chapter 2
50-2-25