New Holland T8010 Manual page 1134

STEP 112
Install the bearing in the pulley and install the internal
snap ring.
STEP 113
Put the pulley and bearing assembly on the front
housing hub. Install a driver on the pulley assembly.
Make sure that the tool is on the inner race of the
bearing.
STEP 114
Support the compressor on the four mounting ears at
the compressor rear. Press the pulley assembly on
the front housing hub. Make sure the bearing is
against the bottom of the hub.
Section 50 - Climate Control - Chapter 2
50-2-73
A21267
RR99D245
RR99D245