New Holland T8010 Manual page 1104

Hide thumbs Also See for T8010:

Table of Contents

Connect the flushing tank hose quick coupler to an

extension or adapter hose.

Connect CLEAN and DRY shop air supply to the

quick coupler on the flushing valve.

Connect flushing and drain hoses to adapters on

compressor lines so flushing solvent moves in the

opposite direction of refrigerant flow - back flushing.

Connect the hose from the flush tank to the suction

line; connect the hose to the return bucket to the

discharge line. Reinforced clear hose is preferred to

monitor the condition and removal of the used

NOTE: Back flushing is done first to dislodge any

contaminants, and then forward flushing is performed

to remove the contaminants.

NOTE: The suction and discharge ports on the

compressor are marked with the letters S and D,

respectively.

IMPORTANT: Secure the lid on the return bucket so

all flush vapors pass through the bucket filter.

Section 50 - Climate Control - Chapter 2

1. FROM THE FLUSH TANK

2. TO RETURN BUCKET

Chapters

Table of Contents

T8020 T8030 T8040