Clearing Full Address Mode; Figure 7.36 Example Of Procedure For Forcibly Terminating Dmac Operation - Renesas H8S/2368 Series Hardware Manual

Forced termination
of DMAC
Clear DTE bit to 0
Forced termination

Figure 7.36 Example of Procedure for Forcibly Terminating DMAC Operation

7.5.16

Clearing Full Address Mode

Figure 7.37 shows the procedure for releasing and initializing a channel designated for full address
mode. After full address mode has been cleared, the channel can be set to another transfer mode
using the appropriate setting procedure.
[1] Clear the DTE bit in DMABCRL to 0.
To prevent interrupt generation after forced
termination of DMAC operation, clear the DTIE bit
to 0 at the same time.
[1]
Rev. 2.00, 05/03, page 267 of 820