Table of Contents
Advertisement
14.9
SCI Interrupts
14.9.1
Interrupts in Normal Serial Communication Interface Mode
Table 14.13 shows the interrupt sources in normal serial communication interface mode. A
different interrupt vector is assigned to each interrupt source, and individual interrupt sources can
be enabled or disabled using the enable bits in SCR.
When the TDRE flag in SSR is set to 1, a TXI interrupt request is generated. When the TEND
flag in SSR is set to 1, a TEI interrupt request is generated. A TXI interrupt can activate the DTC
or DMAC* to perform data transfer. The TDRE flag is cleared to 0 automatically when data
transfer is performed by the DTC or DMAC*.
When the RDRF flag in SSR is set to 1, an RXI interrupt request is generated. When the ORER,
PER, or FER flag in SSR is set to 1, an ERI interrupt request is generated. An RXI interrupt
request can activate the DTC or DMAC* to perform data transfer. The RDRF flag is cleared to 0
automatically when data transfer is performed by the DTC or DMAC*.
A TEI interrupt is generated when the TEND flag is set to 1 while the TEIE bit is set to 1. If a TEI
interrupt and a TXI interrupt are generated simultaneously, the TXI interrupt has priority for
acceptance. However, note that if the TDRE and TEND flags are cleared simultaneously by the
TXI interrupt routine, the SCI cannot branch to the TEI interrupt routine later.
Note: * Not supported by the H8S/2366.
Rev. 2.00, 05/03, page 580 of 820
Advertisement
Table of Contents
