Dram Interface; Setting Dram Space; Address Multiplexing; Table 6.4 Relation Between Settings Of Bits Rmts2 To Rmts0 And Dram Space - Renesas H8S/2368 Series Hardware Manual

6.6

DRAM Interface

In this LSI, external space areas 2 to 5 can be designated as DRAM space, and DRAM interfacing
performed. The DRAM interface allows DRAM to be directly connected to this LSI. A DRAM
space of 2, 4, or 8 Mbytes can be set by means of bits RMTS2 to RMTS0 in DRAMCR. Burst
operation is also possible, using fast page mode.
Note: The DRAM interface is not supported by the H8S/2366.
6.6.1

Setting DRAM Space

Areas 2 to 5 are designated as DRAM space by setting bits RMTS2 to RMTS0 in DRAMCR. The
relation between the settings of bits RMTS2 to RMTS0 and DRAM space is shown in table 6.4.
Possible DRAM space settings are: one area (area 2), two areas (areas 2 and 3), and continuous
area (areas 2 to 5).
Table 6.4 Relation between Settings of Bits RMTS2 to RMTS0 and DRAM Space
RMTS2 RMTS1
0 0
1
1 0
1
With continuous DRAM space, RAS2 is valid. The bus specifications (bus width, number of wait
states, etc.) for continuous DRAM space conform to the settings for area 2.
6.6.2

Address Multiplexing

With DRAM space, the row address and column address are multiplexed. In address multiplexing,
the size of the shift of the row address is selected with bits MXC2 to MXC0 in DRAMCR. Table
6.5 shows the relation between the settings of MXC2 to MXC0 and the shift size.
The MXC2 bit should be cleared to 0 when the DRAM interface is used.
Rev. 2.00, 05/03, page 152 of 820
RMTS0 Area 5
1 Normal space Normal space Normal space DRAM space
0 Normal space Normal space DRAM space
1
0
1
0
1 Continuous
DRAM space
Area 4 Area 3
Reserved (setting prohibited)
Reserved (setting prohibited)
Reserved (setting prohibited)
Reserved (setting prohibited)
Continuous Continuous
DRAM space DRAM space
Area 2
DRAM space
Continuous
DRAM space