Renesas H8S/2368 Series Hardware Manual page 269

Bit Bit Name
9 DTA0
8 —
Initial Value R/W
0 R/W
0 R/W
Description
Data Transfer Acknowledge 0
These bits enable or disable clearing when
DMA transfer is performed for the internal
interrupt source selected by the DTF3 to DTF0
bits in DMACR of channel 0.
It the DTA0 bit is set to 1 when DTE0 = 1, the
internal interrupt source is cleared automatically
by DMA transfer. When DTE0 = 1 and DTA0 =
1, the internal interrupt source does not issue
an interrupt request to the CPU or DTC.
It the DTA0 bit is cleared to 0 when DTE0 = 1,
the internal interrupt source is not cleared when
a transfer is performed, and can issue an
interrupt request to the CPU or DTC in parallel.
In this case, the interrupt source should be
cleared by the CPU or DTC transfer.
When DTE0 = 0, the internal interrupt source
issues an interrupt request to the CPU or DTC
regardless of the DTA0 bit setting.
The state of the DTME0 bit does not affect the
above operations.
Reserved
Though this bit can be read from or written to,
the write value should always be 0.
Rev. 2.00, 05/03, page 217 of 820