Data Bus; Table 6.5 Relation Between Settings Of Bits Mxc2 To Mxc0 And Address Multiplexing - Renesas H8S/2368 Series Hardware Manual

Table 6.5 Relation between Settings of Bits MXC2 to MXC0 and Address Multiplexing
DRAMCR
MXC2 MXC1 MXC0 Shift Size
Row 0 0 0
address
1
1 0
1
x x
1
x x
Column 0
address
x x
1
x: Don't care.
6.6.3

Data Bus

If a bit in ABWCR corresponding to an area designated as DRAM space is set to 1, that area is
designated as 8-bit DRAM space; if the bit is cleared to 0, the area is designated as 16-bit DRAM
space. In 16-bit DRAM space, ×16-bit configuration DRAM can be connected directly.
In 8-bit DRAM space the upper half of the data bus, D15 to D8, is enabled, while in 16-bit DRAM
space both the upper and lower halves of the data bus, D15 to D0, are enabled.
Access sizes and data alignment are the same as for the basic bus interface: see section 6.5.1, Data
Size and Data Alignment.
A23
to
A16 A15 A14 A13 A12 A11 A10 A9 A8 A7 A6 A5 A4 A3 A2 A1 A0
8 bits A23 A23 A22 A21 A20 A19 A18 A17 A16 A15 A14 A13 A12 A11 A10 A9 A8
to
A16
9 bits A23 A15 A23 A22 A21 A20 A19 A18 A17 A16 A15 A14 A13 A12 A11 A10 A9
to
A16
10 bits A23 A15 A14 A23 A22 A21 A20 A19 A18 A17 A16 A15 A14 A13 A12 A11 A10
to
A16
11 bits A23 A15 A14 A13 A23 A22 A21 A20 A19 A18 A17 A16 A15 A14 A13 A12 A11
to
A16
— A23 A15 A14 A13 A12 A11 A10 A9 A8 A7 A6 A5 A4 A3 A2 A1 A0
to
A16
Address Pins
Reserved (setting prohibited)
Reserved (setting prohibited)
Rev. 2.00, 05/03, page 153 of 820