Renesas H8S/2368 Series Hardware Manual page 271

16-bit single-chip microcomputer
Table of Contents

Advertisement

Bit
Bit Name
6
DTE1
Initial Value
R/W
0
R/W
Description
Data Transfer Enable 1
Enables or disables DMA transfer for the
activation source selected by the DTF3 to DTF0
bits in DMACR of channel 1.
When DTE1 = 0, data transfer is disabled and
the activation source is ignored. If the activation
source is an internal interrupt, an interrupt
request is issued to the CPU or DTC. If the
DTIE1 bit is set to 1 when DTE1 = 0, the DMAC
regards this as indicating the end of a transfer,
and issues a transfer end interrupt request to
the CPU.
When DTE1 = 1 and DTME1 = 1, data transfer
is enabled and the DMAC waits for a request by
the activation source. When a request is issued
by the activation source, DMA transfer is
executed.
[Clearing conditions]
When initialization is performed
When the specified number of transfers
have been completed
When 0 is written to the DTE1 bit to forcibly
suspend the transfer, or for a similar reason
[Setting condition]
When 1 is written to the DTE1 bit after reading
DTE1 = 0
Rev. 2.00, 05/03, page 219 of 820

Advertisement

Table of Contents
loading

This manual is also suitable for:

H8s seriesH8s/2300 series

Table of Contents