Clear Bgp Ipv6 Wait-End-Of-Rib - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

clear bgp ipv6 wait-end-of-rib

Syntax
Release Information
Description
Options
Mode
366
clear bgp ipv6 [ unicast | multicast | vpnv6 | route-target signaling ] [ vrf vrfName ]
[ ipAddress | ipv6Address | peer-group peerGroupName | * ] wait-end-of-rib
Command introduced before JunosE Release 7.1.0.
ipv6Address variable added in JunosE Release 8.0.0.
route-target signaling keywords added in JunosE Release 8.2.0.
Resets the IPv6 BGP session and brings down the underlying TCP connection and then
brings it back up again, causing both peers to resend their complete BGP routing table.
Clears the specified peer from the set of peers for which BGP is waiting to receive an
End-of-RIB marker after a peer restart. Hard clearing a peer has the same effect for that
peer. There is no no version.
unicast—Clears the unicast routing table; the default option
multicast—Clears the multicast routing table
vpnv6 —Clears the VPNv6 unicast routing and forwarding table
route-target signaling—Clears the route-target membership information
vrfName—Name of a virtual routing and forwarding instance to clear
ipAddress—IP address of identified BGP neighbor to clear
ipv6Address—IPv6 address of identified BGP neighbor to clear
peerGroupName—Name of a BGP peer group to clear
*—Clears all connections
Privileged Exec
Copyright © 2010, Juniper Networks, Inc.