Bridge-Group - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

bridge-group

Syntax
Release Information
Description
Options
Mode
Related
Documentation
316
bridge-group { bridgeGroupName | vplsName }
[ subscriber-trunk | snmp-trap link-status | learn addressCount ]
no bridge-group { bridgeGroupName | vplsName } [ subscriber-trunk | snmp-trap
link-status | learn ]
Command introduced before JunosE Release 7.1.0.
vplsName variable added in JunosE Release 7.1.0.
Assigns a network interface to a bridge group or VPLS instance. You can also use this
command to configure the type of interface, enable SNMP link-status processing for the
interface, and set the maximum number of dynamic MAC addresses that the interface
can learn. The no version removes the network interface from the bridge group or VPLS
instance and restores the default values for the interface type (subscriber client interface),
SNMP link-status processing (disabled), or number of maximum learned MAC addresses
(0 addresses).
bridgeGroupName—Name of the bridge group to which the interface belongs, as
specified with the bridge command
vplsName—Name of the VPLS instance to which the interface belongs, as specified
with the bridge vpls transport-virtual-router command
subscriber-trunk—Creates a trunk (server) interface in the bridge group or VPLS
instance; if you omit this keyword, the router creates a subscriber (client) interface by
default
snmp-trap link-status—Enables SNMP link-status processing only for the specified
interface in the bridge group or VPLS instance
addressCount—Maximum number of MAC addresses that the interface in the bridge
group or VPLS instance can learn, up to the maximum number that the router supports,
in the range 0–64000
Interface Configuration, Subinterface Configuration
Configuring VPLS Network Interfaces in the JunosE BGP and MPLS Configuration Guide
Copyright © 2010, Juniper Networks, Inc.