Baseline Frame-Relay Interface - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

baseline frame-relay interface

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
baseline frame-relay interface interfaceType interfaceSpecifier [ dlci ]
Command introduced before JunosE Release 7.1.0.
Sets a statistics baseline for Frame Relay and MLFR interfaces, subinterfaces, and circuits.
The router implements the baseline by reading and storing the statistics at the time the
baseline is set and then subtracting this baseline whenever baseline-relative statistics
are retrieved. There is no no version.
interfaceType—One of the following interface types listed in Interface Types and
Specifiers on page 5
mlframe-relay
pos
serial
tunnel
interfaceSpecifier—Particular interface; format varies according to interface type; see
Interface Types and Specifiers on page 5
dlci—DLCI number to be used on the specified subinterface to identify a virtual circuit
in the range 16–1007
Privileged Exec
Chapter 3: B Commands
223