Address Receive Version - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

address receive version

Syntax
Release Information
Description
Options
Mode
102
address { ipAddress | unnumbered interfaceType interfaceSpecifier }
receive version { 1 | 2 | 1 2 | 2 1 | off }
no address [ ipAddress | unnumbered interfaceType interfaceSpecifier ] receive version
Command introduced before JunosE Release 7.1.0.
Restricts the RIP version that the router can receive on an interface. The no version sets
the interface back to the default value, receiving both RIP version 1 and version 2.
ipAddress—Address of IP interface where RIP will be run
unnumbered—Specifies that RIP will be run on an unnumbered interface
interfaceType—Interface type; see "Interface Types and Specifiers" on page 5
interfaceSpecifier—Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
1—Specifies RIP version 1 only
2—Specifies RIP version 2 only
1 2—Specifies RIP version 1 and version 2; the default value
2 1—Specifies RIP version 2 and version 1
off—Turns reception off
Address Family Configuration, Router Configuration
Copyright © 2010, Juniper Networks, Inc.