Adapter Enable - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

adapter enable

Syntax
Release Information
Description
Options
Mode
82
adapter enable adapterSpecifier
Command introduced in JunosE Release 7.1.0.
Enables the IOA installed in the specified IOA bay. There is no no version.
NOTE: For IOAs that support hot-swapping, issuing this command does not
reboot the line module. For IOAs that do not support hot-swapping, issuing
this command reboots the line module associated with the IOA, but it does
not enable it.
To enable the line module and its associated IOAs, issue the slot enable
command.
adapterSpecifier—Particular IOA in the format slot/adapter:
slot—Number of the chassis slot; for E120 routers, in the range 0–5; for E320 routers,
in the range 0–5 or 11–16
adapter—Identifier for the IOA within the chassis slot, either 0 or 1, where:
0 indicates that the IOA is installed in the right IOA bay (E120 router) or the upper
IOA bay (E320 router).
1 indicates that the IOA is installed in the left IOA bay (E120 router) or the lower
IOA bay (E320 router).
Global Configuration
Copyright © 2010, Juniper Networks, Inc.