Table of Contents
Advertisement
JunosE 11.3.x Command Reference Guide A to M
aaa timeout
Syntax
Release Information
Description
Options
Mode
60
To set the default idle timeout:
aaa timeout idle idleTimeout
no aaa timeout idle
To set the default session timeout:
aaa timeout session sessionTimeout
no aaa timeout session
To enable monitoring of only ingress traffic for the configured idle timeout period:
aaa timeout idle ingress-only
no aaa timeout idle [ ingress-only ]
Command introduced before JunosE Release 7.1.0.
ingress-only keyword added in JunosE Release 9.3.0.
Sets the default idle timeout or session timeout for B-RAS PPP users, and optionally
enables the PPP application to monitor only ingress traffic for the configured idle timeout
period to determine whether to disconnect an inactive PPP session. The no version
restores the idle timeout or session timeout to its default value, 0 seconds, and disables
ingress-only traffic monitoring for idle timeout if configured. .
NOTE: To enable ingress-only traffic monitoring for the idle timeout period
by issuing the aaa timeout idle ingress-only command, you must also set
the idle timeout value by issuing the aaa timeout idle command.
idleTimeout—In seconds, 300–86400
sessionTimeout—Time in the range 60–31622400 seconds (that is, a minimum of 1
minute to a maximum of 366 days); the router terminates the user session once the
maximum session timeout is reached, which means that the duration of a PPP or an
L2TP user session cannot exceed 366 days
ingress-only—Enables PPP to monitor only ingress traffic for the configured idle timeout
period to determine whether to disconnect an inactive PPP session; if you do not specify
the ingress-only keyword, PPP monitors both ingress traffic and egress traffic for the
idle timeout period to determine inactivity and subsequent disconnection of an inactive
PPP session
Global Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
